We have fitted a few M11s with kits and they run just as reliably as the M10s. We will begin working our way through the list as soon as we have our magazine perfected.
Magazines: We have approximately 200 magazine bodies back from the laser welder and we are working the bugs out. The 20 and 30 round mags work great. The high cap mags, however, continue to be a bit of a problem. We tested several 40 round mags (in the white) with our local beta testers and it was thumbs up all the way. We then parkerized them and in an effort to save time and reduce costs, we replaced our follower with a Black Dog Machine follower. Before test firing the new follower, we sent them out to beta test volunteers. As soon as we had those practice mags in the mail, we discovered that the Black Dog Machine followers (through no fault of their own) were too small for our spring. The parkerizing also made the inside so rough that the follower would not slide correctly. Our high cap mag that (in the white) would hold 42 rounds were now only allowing 17-20 rounds if you smashed the last rounds into the mag. So, we have modified the followers so that they work with our springs in our mags and sent them out to our volunteers. To avoid the rough interior wall caused by parkerizing, we have set up for bluing the mags to keep a smooth polished finish on the inside. We will be test firing the latest mags this week and are waiting for reports from our volunteers.