Description
This is our “UZI style” folding stock for the M/10. There is only one pivot point for any movement so it is a major improvement over the original sliding stock. The length of the stock is about the same as the sliding stock but the cheek weld is way more comfortable. The stock comes with all necessary attaching hardware and takes about ninety seconds to install it. Once it is installed on your M10 you will never want to remove it! This stock as we build it will be about 10 1/8 inches when opened.
Please select from the following options:
Standard – The butt plate sits right under the barrel when the stock is folded. This is the original and most common configuration.
Sits Away From Upper – The butt place is welded to the other side of the stock arm so that when the stock is folded, the butt plate sticks out to the right of the upper receiver. This configuration is necessary if you will be using long uppers with this stock. If you use the standard configuration, the stock will not lock up correctly.
Folds Left – The stock arm folds to the left. There is an additional charge of $35.00 for this configuration due to the additional machine time.
Note to Powder Springs Gun Owners: Some of the Powder Springs guns have a wider stock block than other M10’s and this may cause the stock to be tight. Thinning out the inside of the stock legs will usually compensate for this. If it is too tight, DO NOT force the stock into your lower receiver. This may cause welds to crack. If you have this problem, contact us for help.
Note: These stocks are built to order so please allow at least 2 weeks for us to build, parkerize and ship them to you. The parts are in stock but the stocks are not assembled until ordered. Gun not included. This stock fits the full auto sub machine gun only. It does not fit on semi auto pistols.
